One alternative is to skip the ledger and end board and attach the ramp joists directly to the floor joist with metal hangers.
Build a ramp for your shed.
Note the rise between the top of the ledger board and the floor.
The first step is to attach the ledger board to the front of the shed.
The down side is that the top and bottom edge of the sheeting will not be fully supported.
Use a circular saw to cut triangular stringers based on your rise and slope measurements.
Therefore we recommend you to plan everything and to adjust the width and the slope of the ramp to suit your needs.
We used a 2 x 4 to estimate a comfortable slope for our ramp and we staked out an area just big enough to fit the concrete blocks.
If you want a shed ramp that withstands heavy loads you will also need to think about additional concrete reinforcement on the ground.
The length of the ramp will be governed by the height from the external ground level to the shed floor and the slope that you choose.
The rise for sheds is often only several inches and riding mowers can easily handle a 1 8 slope.
Pressure treated lumber rated for ground contact should be used to build a shed ramp.
Dig a small trench the full width of the lip of the shed where the 4x4s will touch the ground.
Therefore 12 16 framing is appropriate for most shed ramps.
The nominal size of the boards you select depends on the ramp rise.
There are two main things to consider for your shed ramp plans.
Make sure the framing is not too far apart or the boards on top may sag over time.
Make sure to leave enough room under the door for clearance.
The larger you make the gap the larger the bump at the end of the ramp.
A shed ramp is very handy for any backyard is you use a cart or want a better access to the construction.
Front of the shed for the access ramp.
Along with slope and size there are a few other factors needed when learning how to build a shed ramp.
Cut the support beam to the right size ensure that it is horizontal and affix with screws.
This will save you a little time and excavation effort.
Make sure to consider these when building a garden shed ramp.
How to build a shed ramp put it together cut your frame with the right angles from the slope calculations above.
Next we measured the diagonal distance to the shed to check that it was square.
There are many ways to build a shed ramp.
This will help to anchor the finished ramp in place and keep it from slipping away from the shed when under a heavy load.
It is essential to pour a concrete slab at the ends of the joists as you need to support them properly.
When you ve cut the 4x4s to length lay them on the lip of the shed and mark the spots where the other ends touch the ground.
The recommended distance is between 3 8 and 1 2.
