Now it s time to lift.
Broken awning arm.
It should lock into place.
How to fix broken awning arms.
There is no pin or screw to attach it to the metal rectangular tubing.
Lifting the handles will unlock the awning allowing you to raise it.
If you re raising the awning alone do it in increments on each side.
Today as i opened the awning i found the two sliding arms both broke at the joint where it meets the sliding channel.
Yes the awning was set in the lowered position too as we knew we were going to get rain and we were in the seneca when it broke no wind at all the way that these arms are built is kind of sketchy in the first place and the place it bent is a known weak point on these arms says the owner of the mobile awning company that replaced the arm.
Just wished they didn t rivet the parts together and sold them separately so you could just replace the part that broke without having to replace the entire arm assembly.
So choose from the rv awning parts and accessories that are needed to repair or replace a broken and damaged awning.
Once it s reached the desired height release the handle.
Posted in problems solutions after market.
I looked around on line.
Using the handles on each arm raise the awning.
If you choose to replace you will have roughly double the installation cost as the repair person will first need to remove the old unit before installing the new one.
Program automatic sensors to open for s.
New arm fit perfectly to replace the broken arm.
Remove and replace broken awning cables and arms.
About rv part shop usa s distribution network.
Check wind and sun sensors to verify they are functioning properly.
When your awning becomes slightly damaged it can be far less expensive to replace a couple of the parts rather than purchasing an entirely new unit.
If you send them a photo of the old arm they may be able to match it with some of the universal awning parts they sell.
